|
The RT1000SE would be an excellent addition to any woodworking shop. Cabinet, table and fence are
trimmed in solid Black American Walnut and clear White Maple. | 
The RT1000SE stands 35" from floor to top of the table
surface. Higher with the fence which is included. The table top is 32" wide x 24" deep , hefty 1.1/2" thick for stability
and flatness. This unit weighs in over 125 lbs 
The cabinet is constructed using 18 mm Baltic birch
plywood. This plywood is 13 layers of solid veneers ply's The shelves and uprights are made of 3/4" industrial grade melamine.
Joints are dado, rabbet, glued and brad nailed very well built | 
There are 5 drawers in our router tables. 2 drawers
hold 44 -- 1/4 router bits. 2 drawers hold 28-- 1/2" router bits. We can modify these in case you prefer all 1/2 drawers.
One drawer to store your wrenches, template guides, bearings etc. | | 
The RT1000SE model that comes with a Miter-T-Track
for those miter gauges that have a t-slot bar. Standard miter gauges will also work with this model. There are two electrical
outlets in the base cabinet that are controlled by an Switch on a 8 foot power cord wired for 110-120 volts.
The insert plate is made out of 3/8 Lexan. Very strong and has 8 leveling set screws. One insert
is included with each router table. There are 3 sizes available. (Blank), (2") and (3.5") opening. If not specified at point
of sale a 2" will be included with each order. Insert size is 9 1/4" x 11 3/4" x 3/8". The Same size as most popular router
lifts. The RT1000SE model that comes with a Miter-T-Track for those miter gauges that have a t-slot bar. Standard miter gauges
will also work with this model. | | 
The RT1000SE has a 3.5" dust port on the left side
for attaching your vacuum system (easily adapted to 4"). It has a 2.5" port cut in the top under the fence incase want to
use a smaller hose shop vac. The 3 vented holes in the acrylic door, allow air flow and circulate that keeps the router compartment
free of dust. The(hinged)door covering the router compartment has a magnetic catch to hold the door closed |
The fence includes an alum. t-track for attaching feather boards, stops, guards and other fences and
jigs. Each sliding fence on this split fence system can be adjusted over 1/2" for glue joint work. More importantly, it will
go back to a straight edge in seconds. For vertical panel a high fence can be easily adapted 3 t bolts are included.
The fence sliders will open from 1/2" to 5". You can be set it 1/2" in front of the bit for taking
multiple passes and slide back as much as 5" for routing inside front edge. For those odd shapes or free hand work, set it
completely back and wide open this unit will still collect 99% of the saw dust. |
The bottom cabinet comes fully assembled and packaged in a box surrounded in Styrofoam. 24" x 21"
x 35" The top is shipped in a separate box. 35" x 26" x 5.5" After receiving your RT1000SE, it may takes 10 to 15 minutes
to assemble the top to the lower cabinet using the supplied hardware and mounting instructions, then your ready to go. | |
  | |
Return to Top
|
